Programming Genie wireless Keypad GWKP

Instructions

Programming for 1 Garage Door Opener

Keypad Programming

1. On the keypad enter 3-5-7 in order and press the Program Button. (Red LED flashes 1

time per second)

2. On the keypad enter new PIN number. (3-8 digits)

3. On the keypad press the program button. ( Red LED light flashes 2 times per second

then goes off)

Programming 1 Door Opener to Keypad

1. Find the Learn Code Button and LED light on the opener.

2. On the opener press the Learn Code Button. (The Learn Code LED on the opener will

3. On the keypad enter your PIN Number and press the Up/Down button. (The Learn Code

LED on the opener will stay on)

4. On the keypad press the Up/Down button a second time and the Learn Code LED on the

opener goes off.

5. On the keypad press the Up/Down button a third time and the garage door opens/

*Wait until the backlight on the keypad goes off, about 30 seconds then test the keypad.

Testing the Keypad

1. On the keypad enter your PIN and press the Up/Down button. The garage door should

open/close.

*On the keypad, any button will control opening and closing the garage door while the

keypad backlight is on (about 30 seconds) after the PIN is entered.

If the garage door does not open and close using the wireless keypad, repeat the programming steps

Programming Keypad for Multiple Garage Doors (Up to 3)

All garage doors must use the same PIN

Keypad Programming

1. On the keypad enter 3-5-7 in order and press the Program Button. (Red LED flashes 1

time per second)

2. On the keypad enter new PIN number. (3-8 digits)

3. On the keypad press the Program button. ( Red LED light flashes 2 times per second

then goes off)

4. On the keypad press the number of doors you wish to program 2 or 3.

5. On the keypad press the Program button a third time. ( The red LED will flash several

times then go off)

Programming Garage Door Openers to Keypad

1. Decide what doors will be numbered 1-2-3

2. Locate and press the Learn Code button on the opener. The Learn Code LED on the

opener will start blinking.

3. On the keypad enter the PIN and press the Up/Down button. (The Learn Code LED on

the opener stays on)

4. On the keypad press the door number for this opener, 1, 2or 3. ( Learn Code LED stays

5. On the keypad press the Up/Down button. (Learn Code LED turns off)

*Repeat steps for programming each door opener to the wireless keypad.

*Wait until the backlight on the keypad goes off, about 30 seconds. Then test keypad.

Testing Keypad

1. On the keypad enter PIN

2. On keypad press the Up/Down button

3. Press door number 1, 2 or 3.

4. The selected door should open/close

Compatible with Genie Intellicode openers –